SERIES 800 PhotoController & Beacon Flasher


Data Sheet ( PDF )

Complement to: FAA Advisory Circular AC 150/5345-43F
Canadian Aviation Regulation 621.19
ICAO Annex 14, MIL-C-7989
DGAC of Mexico

 

Use:

The Hughey & Phillips SERIES 800 PhotoController and Beacon Flasher provides a low cost, high reliability solution to your lighting needs.  This unalarmed system allows for the user to add an inline system to their conduit run on the tower to controller the installed FAA beacons and sidelights.  The systems are factory calibrated and never need adjustment.  Each system utilizes surge and transient components and additional input line protection.  Normally closed solid state relay configuration assures “Lights ON” condition even if the circuitry fails.  Red LED provides quick visual verification of field operation.  And with its modular design, it allows for quick field installation or retrofit to existing system is ever damaged.

 
Specifications:        Mounting Requirements:

Input Voltage

120VAC or 230VAC, 50/60Hz

External Dimensions

4-1/2" x 4-1/2" x 3"

Power Rating

2000 Watts continuous duty

Conduit Mounted

1" NPT

Peak Current Surge

320 Amps, 100ms

 

650 Amps, 1 cycle @ 60Hz

Operation Temperature

-55° to +55° C

Transient Suppression

2.5kV @ 10ms
components to case

Reliability

MTBF over 500,000 hrs

Photo Control ON/OFF

ON at or above 35 foot candles

 

OFF at or below 58 foot candles

Beacon Flash Rate

30FPM: 2/3 ON, 1/3 OFF

 

Part Numbers:

            S800PC120 – Photo Controller, 120VAC
            S800PC240 – Photo Controller, 240VAC
           
            S800BF120 – Beacon Flasher, 120VAC
            S800BF240 – Beacon Flasher, 240VAC